Tc Amp Board; Removing The Tc Amp Board - HP Designjet 3D Service Manual

TC Amp board

Required Tools
5
• ⁄ " nut driver or standard screwdriver
16
1
• ⁄ " nut driver
4
Hardware
3
• 10-32 x ⁄ " slotted screws (x7)
8
1
• 6-32 x ⁄ " slotted screws (x3)
4

Removing the TC Amp board

1. Remove the top panel. See
2. Remove the side panels. See
3. Remove the right side access panel mounting screws with a
driver or standard screwdriver and remove the panel. See
Figure 181: Right side access panel mounting screw locations
Remove the 7
mounting screws.
4. Disconnect the umbilical cable by pressing in on the tab and pulling out-
ward. See Figure 182.
"Removing the top panel" on page 161
"Removing the side panels" on page 162
5
⁄ " nut
16
Figure 181.
-239