Establish Communication - HP Designjet 3D Service Manual

(NM) address. Follow the same steps for setting the Netmask (NM) and
Gateway (GW) addresses.
9. When you have finished setting the addresses, press Done. The display
will show: Change IP, Netmask and Gateway?
10. Press Yes. The panel then displays Resetting Network.
1 1. Press Done until Idle is displayed.

Establish communication:

1. From your workstation, start the HP Designjet 3D Software Solution.
A. From the General tab, click the Manage 3D Printers button.
B. Click the Add from Network button in the lower right corner
of the window.
C. A new window, Add 3D Printer, should list your printer
(identified by its UDN). Click on the printer in this window
and enter a name and location of your choice in the lower
portion of the window.
D. Click Add Printer to complete. Close the Add 3D Printer
window.
2. If your printer is not displayed in the Add 3D Printer window, you will
need to add the printer IP address manually.
A. From the General tab, click the Manage 3D Printers button.
B. Click the Add Manually button in the lower right corner of
the window.
C. In the Add 3D Printer window, enter a name and location
of your choice in the appropriate fields.
D. Enter the IP Address for your printer in the appropriate field.
It will be the same address as entered in step 6.
E. Select your printer type from the drop down list, either HP
Designjet 3D or HP Designjet Color 3D.
NOTE: If you only have one printer connected, it will be the only
printer in the list.
F. Click Add Printer and close the Add 3D Printer window.
3. If you are unable to connect the printer to your workstation, contact your
Network Administrator.
-29