HP Designjet 3D Service Manual page 302

16. Using a
Remove the 2
mounting screws
17. Using a
18. Using a
19. Pull the left side Y belt out from the retaining clip.
-286
Figure 251: X motor cable connector location
Disconnect X
motor cable
5
⁄ " nut driver or standard screwdriver, remove the 2 X energy
16
chain mounting bracket mounting screws and set bracket to the side. See
Figure 252.
Figure 252: X motor energy chain mounting bracket mounting screw
5
⁄ " box wrench, remove the outer Y belt retaining clip mount-
16
ing screws from the left side. See
5
⁄ " box wrench, loosen, but do not remove, the inner Y belt
16
retaining clip mounting screws from the left side. See
locations
Figure 253.
Figure 253.