Building A Part; Starting A Build From A Remote Location; Starting A Build From The Display Panel - HP Designjet 3D Service Manual

Building a part

If a part has not been sent to your printer for building, the build queue will
be empty. If the build queue is empty the display panel will show Idle or
Ready to build.
Choose whether or not you want to start a build from a remote location or
from the display panel at the printer.

Starting a build from a remote location:

The lower display will show Wait for Part and it will be flashing.
1. From the display panel press Wait for Part. The display will ask Is
Model Base Installed?
2. Insert a modeling base.
CAUTION: DO NOT reuse modeling bases. If a modeling base is
reused, calibration errors, poor part quality, and loss of extrusion
may occur. Additional modeling bases are available from your HP
reseller.
3. Press Yes. Waiting for Part will now be on the display.
4. From your HP Designjet 3D Software Solution workstation, send a part
to the printer. The printer will automatically start to build the part.

Starting a build from the display panel:

If Wait for Part has not been activated, you can send the part to the printer
and start the part from the display panel after the part has been sent to the
printer.
1. From your HP Designjet 3D Software Solution workstation, send a part
to the printer. The display will show Idle/Ready to Build and the name of
the first file that is in the queue waiting to be built.
2. Insert a modeling base.
CAUTION: DO NOT reuse modeling bases. If a modeling base is
reused, calibration errors, poor part quality, and loss of extrusion
may occur. Additional modeling bases are available from your HP
reseller.
3. From the display panel press Start Model to start building the part.
-43