HP Designjet 3D Service Manual page 252

9. Disconnect the model and support heater cables by pressing in on the
Disconnect the
support side
heater cable
10. Disconnect the toggle sensor cable from the head board by pressing in
Disconnect the toggle
sensor cable from the
head board
1 1. Gently disconnect the toggle sensor cable from the toggle sensor by pull-
-236
Figure 173: Umbilical cable location
Disconnect the
umbilical cable
tabs and pulling outward. See
Figure 174: Model and support heater cable locations
on the tab and pulling outward. See
Figure 175: Toggle sensor cable location
ing the cable outward. See
Figure 174.
Figure 175.
Figure 176.
Disconnect the
model side heater
cable