Electronics Bay Components
The main circuit boards and power supplies for the printer are located in the
electronics bay.
Note: When reinstalling components in the Electronics Bay area
note that cable J401 is unused. (Not connected)
Lower Electronics Bay Cover
Required Tools
5
•
⁄
" nut driver or standard screwdriver.
16
Hardware
3
•
10-32 x
⁄
" slotted screws (x3)
8
Opening the electronics bay
1. Remove the top panel. See
2. Remove the side panels. See
3. Remove the filament tubes from the Y connectors by pushing down on
the ring and pulling back on the filament tubes. See
Figure 78: Removing the filament tubes from the Y connectors
5
4. Using a
⁄
" nut driver or standard screwdriver, remove the 3 mounting
16
screws on the top of the electronics bay cover. See
"Removing the top panel" on page 161
"Removing the side panels" on page 162
Figure 79.
Figure 78.
-171