Umbilical Cable; Removing The Umbilical Cable - HP Designjet 3D Service Manual

Umbilical Cable

Required Tools
5
• ⁄ " nut driver or standard screwdriver
16
• Cutters
1
• ⁄ " nut driver
4
5
• ⁄ " allen wrench
32

Removing the umbilical cable

1. Remove the top panel. See
2. Remove the side panels. See
3. Remove the upper electronics bay cover. See
tronics bay cover" on page 173
4. Remove the umbilical hose. See
page 241
5. Disconnect the umbilical cable from the I/O card. See
Figure 193: Umbilical cable connector locations
6. Disconnect the umbilical cable from the head board by pressing in on
the tab and pulling upward. See
"Removing the top panel" on page 161
"Removing the side panels" on page 162
"Removing the upper elec-
"Removing the umbilical hose" on
Disconnect the 2
umbilical cables from the
I/O card
Figure 194.
Figure 193.
-247