HP Designjet 3D Service Manual page 296

Installing the Y Drive Rod
1. Slide the Y drive rod through the Y belts and into position.
2. Align Y drive rod with the 6 mounting holes.
3. Using a
4. Place the Y motor belt around the Y motor pulley.
5. Lift the Y motor until the Y belt is tight and use a
6. Align the foam insert over the mounting brackets.
7. Using a
8. Align the head cooling fan mounting bracket and Use a
9. Reconnect the head cooling fan.
10. Using a
1 1. Using a
12. Reinstall the Electronics Bay. See
13. Reinstall the upper electronics bay cover. See
14. Place the left and right Y belts into the retaining clips. Do not tighten the
15. Tension the Y belts. See
16. Reinstall the left and right side access panels.
17. Reinstall the front panel. See
18. Reinstall the Side panels. See
19. Reinstall the top panel. See
20. Reconnect the material bay cable, network cable and power cable.
-280
5
⁄ " nut driver or standard screwdriver, reinstall the 6 Y drive
16
rod mounting screws.
dard screwdriver to tighten the 4 Y motor mounting bracket mounting
screws.
5
⁄ " nut driver or standard screwdriver reinstall the 4 foam
16
retaining screws and washers.
or standard screwdriver to reinstall the 2 mounting bracket screws.
5
⁄ " nut driver or standard screwdriver reinstall the left side
16
access panel.
5
⁄ " nut driver or standard screwdriver reinstall the right side
16
access panel.
page 176
tronics bay cover" on page 174
retaining clips at this time.
on page 384
"Installing the electronics bay" on
"Installing the upper elec-
"Checking/Adjusting the Y-Drive Belt Tension"
"Installing the front panel" on page 168
"Installing the side panels" on page 164
"Installing the top panel" on page 162
5
⁄ " nut driver or stan-
16
5
⁄ " nut driver
16