Installing The Substrate Sensor - HP Designjet 3D Service Manual

Installing the substrate sensor

1. Align the substrate sensor with the mounting holes.
2. Using a
3. Reconnect the substrate sensor wire to the head board.
4. Reinstall the wire tie around the head motor and wires. See
5. Align the right side access panel with the mounting holes.
6. Using a
7. Reinstall the side panels. See
8. Reinstall the top panel. See
-222
3
⁄ " allen wrench, reinstall the 4 substrate sensor mounting
32
screws.
Figure 153: Wire tie location
5
⁄ " nut driver, reinstall the right side access panel mounting
16
screws.
"Installing the side panels" on page 164
"Installing the top panel" on page 162
Figure 153.
Reinstall the wire tie
around the head motor