Removing The Right Side Panel; Installing The Side Panels - HP Designjet 3D Service Manual

Removing the right side panel:

1. Using a
2. Slide towards the back of the printer and pull outward to remove. See

Installing the side panels

1. Slide the left side panel towards the front of the printer and push into
2. Using a
3. Slide the right side panel towards the front of the printer and push into
4. Using a
5. Reinstall the top panel. See
-164
5
⁄ " nut driver or standard screwdriver, remove the 3 mounting
16
screws. See Figure 67.
Figure 67: Right side panel mounting screw locations
Remove the 3 right side
panel mounting screws.
Figure 68.
Figure 68: Removing the right side panel
Pull the right side panel out and
towards the back of the printer to
remove.
place.
5
⁄ " nut driver or standard screwdriver, Reinstall the 3 mounting
16
screws.
place.
5
⁄ " nut driver or standard screwdriver, Reinstall the 3 mounting
16
screws.
"Installing the top panel" on page 162