HP Designjet 3D Service Manual page 310

5
30. Using a ⁄ " box wrench, tighten the right side Y belt clamp mounting
16
screws.
5
31. Using a ⁄ " box wrench, tighten the left side Y belt clamp mounting
16
screws.
5
32. Using a ⁄ " allen wrench, securely fasten the left rear Y guide rod
32
mounting screw.
33. Reinstall the head board. See
34. Reinstall the TC Amp board. See
page 241
35. Reinstall the substrate sensor. See
page 222
36. Reinstall the toggle head assembly. See
assembly" on page 217
37. Reinstall the toggle sensor. See
page 226
38. Install the 2 XY table alignment brackets to the center of the Y guide
rods. See Figure 266.
39. Adjust the alignment brackets as needed.
1
40. Using a ⁄ " allen wrench, tighten the alignment bracket adjustment
8
screws.
Figure 266: XY Table alignment bracket center mounting location
Center the alignment
brackets
41. Move 1 alignment bracket to the front of the printer. See
42. Move the translator to the center of the XY table.
43. Move 1 alignment bracket to the rear of the printer. See
"Installing the head board" on page 238
"Installing the TC Amp board" on
"Installing the substrate sensor" on
"Installing the toggle head
"Installing the toggle sensor" on
Figure 267.
Figure 267.
-294