120Vdc Power Supply; Removing The 120Vdc Power Supply - HP Designjet 3D Service Manual

120VDC Power Supply

Required Tools
Hardware

Removing the 120VDC power supply

1. Remove the top panel. See
2. Remove the side panels. See
3. Remove the electronics bay. See
4. Using a
Remove the 3
mounting screws
5. Open the rear panel of the electronics bay.
6. Touch the metal plate of the electronics bay cover to discharge any static
7. Disconnect the J601 connector by pressing the tab and pulling the con-
-208
5
• ⁄ " nut driver or standard screwdriver.
16
• Phillips screwdriver
3
• 10-32 x ⁄ " slotted screws (x3)
8
1
• 6-32 x ⁄ " Phillips pan head screws (x3)
4
page 175
5
⁄ " nut driver or standard screwdriver, remove the 3 rear elec-
16
tronics bay mounting screws. See
Figure 130: Rear electronics bay mounting screw locations
electricity.
nector up. See Figure 131.
"Removing the top panel" on page 161
"Removing the side panels" on page 162
"Removing the electronics bay" on
Figure 130.