HP Designjet 3D Service Manual page 449

9. From the Baud Rate: pull-down menu select 38400, see
10. From the Flow Control: pull-down menu select hardware, see
438
1 1. The rest of the settings should default to the correct values. Click OK, see
Figure 438
12. The connection should now be established.
A. To test the connection, type ss and press the Enter key.
"Information should post on the screen if the connection
was successful.
NOTE: "If text does not appear in Tera Term you may have the
wrong COM Port selected, there may be an issue with the Null
Modem Cable or there may be an issue with the USB to serial
converter.
Figure 437: Setup Serial Port
Figure 438: Serial Port Setup
Figure 438
Figure
-433