Xy Table Assembly Installation Checklist - HP Designjet 3D Service Manual

XY Table Assembly Installation Check-
list
If you have any questions before or during installation, do not hesitate to call
your Customer Support provider.
-422
Replace the XY table Assembly.
Verify that all electrical leads are connected correctly
Perform the XY Leveling procedure
Check/Adjust the X-Drive Belt tension
Check/Adjust the Y-Drive Belt tension
Manually move the table in both the X and Y direction to ensure it moves
smoothly.
Clean and vacuum the system.
Power system up and verify that system homes correctly.
Load material.
Perform the Part Based Calibration procedure.
Perform the Z Calibration and XY Offset Calibration.
Run a small test part to ensure part quality is acceptable and that the XY
table is functioning correctly.