Power Distribution Board (PDB)
Required Tools
5
•
⁄
" nut driver or standard screwdriver.
16
•
Phillips screwdriver
Hardware
1
•
6-32 x
⁄
" Phillips pan head screws (x12)
4
1
•
10-32 x
⁄
" slotted screws (x8)
2
Removing the power distribution board
1. Remove the top panel. See
2. Remove the side panels. See
3. Open the electronics bay. See
page 171
4. Touch the metal plate of the electronics bay cover to discharge any static
electricity.
5. Remove the I/O card. See
5
6. Using a
⁄
" nut driver or standard screwdriver, remove the 4 screws on
16
the left and right side of the electronics bay and carefully slide the elec-
tronics bay out of the printer about 3 inches (76mm). See
"Removing the top panel" on page 161
"Removing the side panels" on page 162
"Opening the electronics bay" on
"Removing the I/O card" on page 185
Figure 100.
-187