HP Designjet 3D Service Manual page 367

31. Press the GRight button. Enter the value recorded from step
ing the Increment, Decrement and Next Digit buttons.
NOTE: The value for GRight must be between 5.250" and 5.750".
32. When finished, press Done...
33. Press the GFront button. Enter the value recorded from step
ing the Increment, Decrement and Next Digit buttons.
NOTE: The value for GFront must be between 7.250" and 7.750".
34. When finished, press Done...
35. Press the Next... button.
36. Press the GRear button. Enter the value recorded from step
ing the Increment, Decrement and Next Digit buttons.
NOTE: The value for GRear must be between 7.250" and 7.750".
37. When finished, press Done...
38. Press the GLF button. Enter the value recorded from step
the Increment, Decrement and Next Digit buttons.
NOTE: The value for GLF must be between 9.051" and 9.551".
39. When finished, press Done...
40. Press the GLR button. Enter the value recorded from step
the Increment, Decrement and Next Digit buttons.
NOTE: The value for GLR must be between 9.051" and 9.551".
41. When finished, press Done...
42. Press the Next... button until you reach the last page.
43. Press the Done... button.
44. Press the Save and reboot button.
45. The printer will reboot and return to idle.
46. Build a sample part to verify proper operation.
by press-
17
by press-
12
by press-
16
by pressing
26
by pressing
22
-351