Remove the 4
mounting screws
8. Remove the Y motor.
Installing the Y motor
1. Align the Y motor with the Y motor mounting bracket, making sure the Y
2. Using a
3. Align the Y motor mounting bracket with mounting holes.
4. Using a
5. Place the Y motor belt around the Y motor pulley.
6. Slide the Y motor mounting bracket up until the Y belt is tight.
7. Using a
8. Reconnect the Y motor cable.
9. Align the left side access panel with the mounting holes.
10. Using a
1 1. Reinstall the upper electronics bay cover. See
12. Reinstall the side panels. See
13. Reinstall the top panel. See
-262
Figure 216: Y motor mounting screw locations
motor cable faces the back of the printer.
9
⁄
" allen wrench, reinstall the 4 Y motor mounting screws.
64
5
⁄
" nut driver or standard screwdriver, loosely reinstall the Y
16
motor mounting bracket mounting screws.
5
⁄
" nut driver or standard screwdriver, securely fasten the Y
16
motor mounting bracket mounting screws.
5
⁄
" nut driver or standard screwdriver, reinstall the left side
16
access panel mounting screws.
tronics bay cover" on page 174
"Installing the upper elec-
"Installing the side panels" on page 164
"Installing the top panel" on page 162