Installing The Z Motor - HP Designjet 3D Service Manual

Installing the Z motor

1. Place the Z motor in its mounting location and loosely fasten the
2. Insert the leadscrew and turn clockwise until the leadscrew clears the
3. Raise the Z stage to the upper limit and tighten the leadscrew mounting
4. Lower the Z stage down to its lower limit and tighten the Z stage motor
5. Align the Z stage motor energy chain and fasten the mounting screws,
6. Attach and tighten the wire ties on both ends of the Z motor wire.
7. Reinstall the Z stage panel and tighten the 4 mounting screws with a
8. Reinstall the electronics bay. See
9. Reinstall the upper electronics bay cover. See
10. Reinstall the side panels. See
1 1. Reinstall the top panel. See
-324
3
mounting screws with a
bottom of the motor.
bracket set screws.
mounting screws.
be sure not to overtighten and crush the energy chain.
Figure 307: Remove the Z motor energy chain
5
⁄ " nut driver or standard screwdriver.
16
page 176
tronics bay cover" on page 174
⁄ " allen wrench.
32
"Installing the electronics bay" on
"Installing the upper elec-
"Installing the side panels" on page 164
"Installing the top panel" on page 162
Reinstall the wire
tie
Reinstall the wire
tie