HP Designjet 3D Service Manual page 345

Figure 31 1: Z stage leadscrew mounting bracket locations
Z Stage
leadscrew
mounting
brackets
15. Raise the Z stage up all the way and insert the Z stage leadscrew align-
ment fixture at the bottom of the guide rods. See
16. Once the alignment fixture is in properly, turn the locking screws 1/4
turn counter clockwise to lock in place. See
Figure 312: Inserting the Z stage guide rod alignment fixture
5
17. Using a ⁄ " socket driver or
16
lower Z stage leadscrew mounting bracket screws from the backside of
the printer.
18. Remove the Z stage leadscrew alignment fixture by pressing in the
1
screws and turning
Figure 312.
5
⁄ " box wrench, securely fasten the
16
⁄ turn clockwise to unlock.
4
Figure 312.
-329