HP Designjet 3D Service Manual page 373

Figure 349: Measuring diameter of circle D
23. Add the lengths derived from steps 20 and 21 (C-D and D-E) and then
subtract the width of circle D derived from step 22. Record this total as
"Left Rear"
24. Measure and record the distance from the outside edge of the small
bump on circle A to the outside edge of circle D. See
Figure 350: Measuring distances from outside edges of A and D
25. Measure and record the distance from the outside edge of the small
bump on circle G to the outside edge of circle D. See
Figure 350
Figure 351
-357