Removing The Z Stage - HP Designjet 3D Service Manual

Hardware

Removing the Z stage

1. Remove the top panel. See
2. Remove the side panels. See
3. Remove the electronics bay. See
4. Remove the Z motor. See
5. Tilt the printer forward 6 inches (152mm) and prop up with a material
-326
• Z Guide rod spacer (x2)
• Head bracket, dial indicator and belt tension gauge assembly
• Z guide rod alignment fixture
1
• 10-32 x ⁄ " slotted screws (x4)
2
page 175
carrier or something similar.
"Removing the top panel" on page 161
"Removing the side panels" on page 162
"Removing the electronics bay" on
"Removing the Z motor" on page 321