Installing The 5/12Vdc Power Supply - HP Designjet 3D Service Manual

10. Using a Phillips screwdriver, remove the 3 mounting screws. See
129.
Figure 129: 5/12 VDC supply mounting screw locations
1 1. Remove the 5/12VDC power supply.

Installing the 5/12VDC power supply

1. Align the 5/12VDC power supply and press down into place.
2. Using a Phillips screwdriver, reinstall the 3 mounting screws.
3. Reconnect the SK2 connector.
4. Reconnect the J2 spade connector.
5. Close the rear panel of the electronics bay.
5
6. Using a ⁄ " nut driver or standard screwdriver, reinstall the 3 rear elec-
16
tronics bay mounting screws.
7. Reinstall the electronics bay. See
page 176
8. Reinstall the side panels. See
9. Reinstall the top panel. See
"Installing the electronics bay" on
"Installing the side panels" on page 164
"Installing the top panel" on page 162
Figure
-207