Installing The Y Motor Belt - HP Designjet 3D Service Manual

Installing the Y Motor Belt

1. Slide the Y motor belt over the Y drive rod.
2. Align Y drive rod with the 6 mounting holes.
5
3. Using a ⁄ " nut driver or standard screwdriver, reinstall the 6 Y drive
16
rod mounting screws.
4. Place the Y motor belt around the Y motor pulley.
5. Lift the Y motor until the Y belt is tight and use a
dard screwdriver to tighten the 4 Y motor mounting bracket mounting
screws.
6. Align the foam insert over the mounting brackets.
5
7. Using a ⁄ " nut driver or standard screwdriver reinstall the 4 foam
16
retaining screws and washers.
8. Align the head cooling fan mounting bracket and Use a
or standard screwdriver to reinstall the 2 mounting bracket screws.
9. Reconnect the head cooling fan.
5
10. Using a ⁄ " nut driver or standard screwdriver reinstall the left side
16
access panel.
5
1 1. Using a ⁄ " nut driver or standard screwdriver reinstall the right side
16
access panel.
12. Reinstall the Electronics Bay. See
page 176
13. Reinstall the upper electronics bay cover. See
tronics bay cover" on page 174
14. Place the left and right Y belts into the retaining clips. Do not tighten the
retaining clips at this time.
15. Tension the Y belts. See
on page 384
16. Reinstall the left and right side access panels.
17. Reinstall the front panel. See
18. Reinstall the Side panels. See
19. Reinstall the top panel. See
20. Reconnect the material bay cable, network cable and power cable.
"Installing the electronics bay" on
"Installing the upper elec-
"Checking/Adjusting the Y-Drive Belt Tension"
"Installing the front panel" on page 168
"Installing the side panels" on page 164
"Installing the top panel" on page 162
5
⁄ " nut driver or stan-
16
5
⁄ " nut driver
16
-271