Toggle Head Assembly; Removing The Toggle Head Assembly - HP Designjet 3D Service Manual

Toggle Head Assembly

Required Tools
Hardware

Removing the toggle head assembly

1. Remove the top panel. See
2. Remove the side panels. See
3. Using a
4. Remove the head cover by pressing the tabs in and pulling the cover out-
-212
5
• ⁄ " nut driver or standard screwdriver.
16
• Cutters
• Wire tie (x1)
3
• 10-32 x ⁄ " slotted screws (x7)
8
1
• 10-32 x ⁄ " slotted screws (x4)
2
5
⁄ " nut driver or standard screwdriver, remove the right side
16
access panel mounting screws and remove the panel. See
Figure 135: Right side access panel mounting screw locations
Remove the 7
mounting screws.
ward. See Figure 136.
"Removing the top panel" on page 161
"Removing the side panels" on page 162
Figure 135.