Removing The Electronics Bay - HP Designjet 3D Service Manual

Removing the Electronics Bay

Required Tools
5
• ⁄ " nut driver or standard screwdriver.
16
Hardware
1
• 10-32 x ⁄ " slotted screws (x8)
2
Removing the electronics bay
1. Remove the top panel. See
2. Remove the side panels. See
3. Remove the upper electronics bay cover. See
tronics bay cover" on page 173
4. Touch the metal plate of the electronics bay cover to discharge any static
electricity.
5. Disconnect the 6 I/O card cables by pressing down on the long tabs
and pulling out. See
6. Disconnect the chamber thermocouple wire. See
Figure 83: I/O card cable locations
I/O Card cable
locations
7. Remove the left and right side electronics bay mounting screws with a
5
⁄ " nut driver or standard screwdriver. See
16
"Removing the top panel" on page 161
"Removing the side panels" on page 162
Figure 83.
Chamber thermocouple
wire location
Figure 84.
"Removing the upper elec-
Figure 83.
-175