Installing The Toggle Sensor - HP Designjet 3D Service Manual

5. Using a standard screwdriver, remove the 2 toggle sensor mounting
6. Remove the toggle sensor.

Installing the toggle sensor

1. Align the toggle sensor with the mounting holes.
2. Using a standard screwdriver, reinstall the 2 mounting screws.
3. Reconnect the toggle sensor wire to the toggle sensor.
4. Align the right side access panel with the mounting holes.
5. Using a
6. Reinstall the side panels. See
7. Reinstall the top panel. See
-226
Figure 157: Toggle sensor wire connector location
screws. See Figure 158.
Figure 158: Toggle sensor mounting screw locations
5
⁄ " nut driver or standard screwdriver, reinstall the right side
16
access panel mounting screws.
Gently disconnect the
toggle sensor cable
Remove the 2
mounting screws
"Installing the side panels" on page 164
"Installing the top panel" on page 162