Installing The Electronics Bay Cooling Fan - HP Designjet 3D Service Manual

7. Remove the cooling fan.

Installing the electronics bay cooling fan

1. Align the cooling fan with the 4 mounting holes.
2. Using a
3. Reconnect the P1 cable.
4. Close the electronics bay. See
5. Install the side panels. See
6. Install the top panel. See
-178
Figure 87: Electronics bay cooling fan mounting screw locations
5
⁄ " allen wrench, reinstall the 4 mounting screws.
64
page 172
"Closing the electronics bay" on
"Installing the side panels" on page 164
"" on page 162
Remove the 4 mounting
screws