HP Designjet 3D Service Manual page 289

Figure 231: Left side access panel mounting screw locations
Remove the 7
mounting screws.
5. Disconnect the material bay cable from the printer.
6. Remove the Front Panel. See
7. Remove the Electronics Bay. See
page 175
5
8. Using a ⁄ " nut driver or standard screwdriver, remove the right side
16
access panel mounting screws and remove the right side access panel.
See Figure 232.
Figure 232: Right side access panel mounting screw locations
Remove the 7
mounting screws.
5
9. Using a ⁄ " box wrench, remove the outer Y belt retaining clip mount-
16
ing screws from the left side. See
5
10. Using a ⁄ " box wrench, loosen, but do not remove, the inner Y belt
16
retaining clip mounting screws from the left side. See
1 1. Pull the left side Y belt out from the retaining clip.
"Removing the front panel" on page 166
"Removing the Electronics Bay" on
Figure 233.
Figure 233.
-273