Installing The 120 Vdc Power Supply - HP Designjet 3D Service Manual

Figure 131: J601 connector location
8. Using a Phillips screwdriver, remove the 3 mounting screws. See
132.
Figure 132: 120 VDC mounting screw locations
9. Remove the 120VDC power supply.

Installing the 120 VDC power supply

1. Align the 120VDC power supply with the mounting holes.
2. Using a Phillips screwdriver, reinstall the 3 mounting screws.
3. Reconnect J601.
4. Close the rear panel of the electronics bay.
5
5. Using a ⁄ " nut driver or standard screwdriver, reinstall the 3 rear elec-
16
tronics bay mounting screws.
6. Reinstall the electronics bay. See
page 176
7. Reinstall the side panels. See
8. Reinstall the top panel. See
"Installing the electronics bay" on
"Installing the side panels" on page 164
"Installing the top panel" on page 162
Disconnect
J601
Figure
-209