Installing The Power Distribution Board - HP Designjet 3D Service Manual

Installing the power distribution board

1. Align the power distribution board with the mounting holes.
2. Using a Phillips screwdriver, reinstall the 12 mounting screws.
3. Reconnect the 10 cables to the front of the power distribution board.
4. Carefully slide the electronics bay out 3 inches (76mm) and reconnect
5. Carefully slide the electronics bay back into position.
6. Using a
7. Reinstall the I/O card. See
8. Close the electronics bay. See
9. Reinstall the side panels. See
10. Reinstall the top panel. See
-190
the 4 cables to the back of the PDB.
5
⁄ " nut driver or standard screwdriver, reinstall the 8 mounting
16
screws on the left and right sides.
page 172
"Installing the I/O card" on page 186
"Closing the electronics bay" on
"Installing the side panels" on page 164
"Installing the top panel" on page 162