HP Designjet 3D Service Manual page 273

6. Align the X motor energy chain mounting bracket with the mounting
holes.
5
7. Using a ⁄ " nut driver or standard screwdriver, reinstall the 2 X motor
16
energy chain mounting screws.
8. Reconnect the X motor cable.
9. Reinstall a wire tie around the X motor cable connector. See
Figure 208: X motor wire tie locations
Reinstall wire tie
10. Move the Head Assembly to the full right travel position within the build
envelope (as viewed from the front of the printer).
1 1. Insert the zero gauge block into the gauge. See
12. Loosen the adjustment screw and slide the dial indicator assembly up or
down to set the 'zero' reading: The large hand should be on 0 and the
small hand on 5.
13. Tighten the adjustment screw (do not over tighten the screw) and recheck
the reading.
14. Remove the zero block gauge block from the fixture.
Figure 208.
Figure 209.
-257