Toggle Sensor; Removing The Toggle Sensor - HP Designjet 3D Service Manual

Toggle Sensor

Required Tools
5
• ⁄ " nut driver or standard screwdriver.
16
3
• ⁄ " allen wrench.
32
Hardware
1
• 4-40 x ⁄ " slotted screws (x2)
4

Removing the toggle sensor

1. Remove the top panel. See
2. Remove the side panels. See
3. Remove the right side access panel. See
Figure 156: Right side access panel mounting screw locations
Remove the 7
mounting screws.
4. Gently disconnect the toggle sensor wire by pulling outwards. See
ure 157.
"Removing the top panel" on page 161
"Removing the side panels" on page 162
Figure 156.
Fig-
-225