Power Switch
Required Tools
5
•
⁄
" nut driver or standard screwdriver.
16
Hardware
3
•
10-32 x
⁄
" slotted screws (x2)
8
Removing the Power Switch
1. Remove the top panel. See
2. Remove the left side panel. See
page 162
5
3. Using a
⁄
" nut driver or standard screwdriver, remove the 2 power
16
switch housing mounting screws. See
Figure 1 16: Power switch housing mounting screw locations
Remove the 2
mounting screws
4. Remove the white SW2 wire from the spade connector labeled "3". See
Figure 1 17.
5. Remove the black SW3 wire from the spade connector labeled "1a".
See
Figure 1 17.
6. Remove the yellow NC wire from the spade connector labeled "2a".
See
Figure 1 17.
7. Remove the green COM wire from the spade connector labeled "2".
See
Figure 1 17.
"Removing the top panel" on page 161
"Removing the side panels" on
Figure 1 16.
-199