HP Designjet 3D Service Manual page 281

Figure 219: Left side Y belt retaining clip mounting screw locations
Remove the outer
mounting screws
Loosen, but do not
remove the inner
mounting screws
5
12. Using a ⁄ " box wrench, remove the outer Y belt retaining clip mount-
16
ing screws from the right side. See
5
13. Using a ⁄ " box wrench, loosen, but do not remove, the inner Y belt
16
retaining clip mounting screws from the right side. See
14. Pull the right side Y belt out from the retaining clip.
Figure 220: Right side Y belt retaining clip mounting screw locations
Remove the outer
mounting screws
Loosen, but do not
remove the inner
mounting screws
15. Decrease the Y belt tension by turning the tensioning nut, see
Figure 220.
Figure 220.
Figure 221.
-265