Reinstalling The Single Board Computer; Power Distribution I/O Card - HP Designjet 3D Service Manual

Reinstalling the single board computer

1. Reconnect the display cable.
2. Using a standard screwdriver, tighten the display cable mounting
3. Align the SBC with the mounting holes.
4. Using a Phillips screwdriver, reinstall the 4 mounting screws.
5. Reconnect the RJ-45 network cable.
6. Reconnect the SATA cable.
7. Reconnect the J2 power cable.
8. Reinstall the controller board. See
9. Close the electronics bay. See

Power Distribution I/O Card

Required Tools
Hardware
-184
Figure 95: SBC display cable location
screws.
page 181
page 172
5
• ⁄ " nut driver or standard screwdriver.
16
• Phillips screwdriver
1
• 6-32 x ⁄ " Phillips pan head screws (x3)
4
"Installing the controller board" on
"Closing the electronics bay" on
Disconnect the
Display cable