HP Designjet 3D Service Manual page 253

Figure 176: Disconnect the toggle sensor cable from the toggle sensor
1
12. Using a ⁄ " nut driver or standard screwdriver, remove the toggle sensor
4
cable retaining clips. See
Figure 177: Toggle sensor cable retaining clip locations
Remove the 2 toggle
sensor cable retaining clips
13. Feed the toggle sensor cable out through the head board. See
178.
Figure 178: Removing the toggle sensor cable from the head board
Feed toggle sensor cable
through the head board
14. Disconnect the substrate sensor cable and filament motor cables from
the rear of the head board by pressing the tabs in and pulling outward.
See Figure 179.
Gently disconnect the
toggle sensor cable
Figure 177.
Figure
-237