Installing The Y Eot Sensor - HP Designjet 3D Service Manual

Figure 198: Y EOT sensor cable location
Disconnect the Y
EOT cable
1
3. Using a ⁄ " nut driver or standard screwdriver, remove the mounting
4
screw. See Figure 199.
Figure 199: Y EOT sensor mounting screw location
Remove the
mounting screw
4. Remove the Y EOT sensor.

Installing the Y EOT Sensor

1. Align the Y EOT Sensor with the mounting hole.
1
2. Using a ⁄ " nut driver or standard screwdriver, reinstall the mounting
4
screw.
3. Reconnect the Y EOT cable.
4. Install the top panel. See "Installing the top panel" on page 162
-251