10. Using a
1 1. Remove the substrate sensor. See
12. Using a
13. Remove the tensioning fork and pulley from the X motor belt.
-284
Figure 247: Umbilical hose wire tie location
Cut and remove
the wire tie
5
⁄
" allen wrench, remove the 2 energy chain mounting
32
screws. See
Figure 248.
Figure 248: Energy chain mounting screw locations
Remove the 2
mounting screws
page 220
1
⁄
" box wrench, remove the X belt tension adjuster by loosen-
2
ing the inside nut and then backing the bolt out of the mount. See
249.
"Removing the substrate sensor" on
Figure