Figure 107: Hard drive mounting bracket screw locations
Remove mounting
brackets
Installing the hard drive
1. Using a Phillips screwdriver, reinstall the 2 mounting brackets.
2. Push the hard drive in the slots and down into position.
3. Using a Phillips screwdriver, reinstall the 4 mounting screws.
4. Reconnect the SATA cable.
5. Reconnect the power input cable.
6. Close the electronics bay. See
page 172
7. Power up the printer. The printer may take up to 45 minutes to run the
Check Disc command before you see anything on the display panel.
8. After the printer has rebooted and is idle, press Maintenance > System >
Set Network.
9. Select either Dynamic networking or Static networking.
10. If using Static networking, enter the printers IP Address, Default Gateway
and Subnet Mask values.
1 1. From the PC, open the HP Designjet 3D Software Solution.
12. Connect to the printer.
13. Insert the printer firmware CD into the workstation CD drive.
14. From the Printer Services tab, click on the Update Software button.
15. Navigate HP Designjet 3D Software Solution to the Upgrade (.UPG) file
on the printer firmware CD.
16. The printer will load, reboot and verify the upgrade.
"Closing the electronics bay" on
-193