Installing The Upper Electronics Bay Cover - HP Designjet 3D Service Manual

5. Lift the cover up and off of the top mounting screws.

Installing the upper electronics bay cover

1. Slide the cover down on to the top left and right side mounting screws.
2. Using a
3. Using a
4. Install the side panels. See
5. Install the top panel. See
-174
Figure 82: Upper electronics bay cover bottom mounting screw locations
Remove the bottom left and
right mounting screws
5
⁄ " nut driver or standard screwdriver, reinstall the bottom left
16
and right side mounting screws.
5
⁄ " nut driver or standard screwdriver, tighten the top left and
16
right side mounting screws.
"Installing the side panels" on page 164
"Installing the top panel" on page 162