Substrate Sensor
Required Tools
Hardware
Removing the substrate sensor
1. Remove the top panel. See
2. Remove the side panels. See
3. Using a
4. Disconnect the substrate sensor wire from the head board by pressing in
-220
5
•
⁄
" nut driver or standard screwdriver.
16
3
•
⁄
" allen wrench.
32
•
Wire tie (x1)
3
•
10-32 x
⁄
" slotted screws (x7)
8
1
•
4-40 x
⁄
" slotted screws and # 4 split lock washer (x4)
4
5
⁄
" nut driver, remove the 7 right side access panel mounting
16
screws. See
Figure 149.
Figure 149: Right side access panel mounting screw locations
Remove the 7
mounting screws.
on the tab and pulling outward. See
"Removing the top panel" on page 161
"Removing the side panels" on page 162
Figure 150.