Upper Electronics Bay Cover; Removing The Upper Electronics Bay Cover - HP Designjet 3D Service Manual

Upper Electronics Bay Cover

Required Tools
5
• ⁄ " nut driver or standard screwdriver.
16
Hardware
3
• 10-32x ⁄ " slotted screws (x4)
8

Removing the upper electronics bay cover

1. Remove the top panel. See
2. Remove the side panels. See
5
3. Using a ⁄ " nut driver or standard screwdriver, loosen but do not
16
remove the top left and right mounting screws. See
Figure 81: Upper electronics bay cover top mounting screw locations
Loosen but do not
remove the 2
mounting screws
5
4. Using a ⁄ " nut driver or standard screwdriver, remove the bottom left
16
and right mounting screws. See
"Removing the top panel" on page 161
"Removing the side panels" on page 162
Figure 81.
Figure 82.
-173