Position And Temperatures; Versions; Travel Limits - HP Designjet 3D Service Manual

Position and Temperatures

Current Position The current X, Y and Z position in micro steps.
X and Y = 16000 micro-steps per inch.
Z = 128000 micro-steps per inch.
Current / Total The current build layer and the total number of layers in
the model
Layers
Current Curve The current curve (toolpath) number of the model
Current Vertex The current vertex (series of connected points) number of
the model.
Head Temp The actual head temperature and its set point in C.
Head PWM The pulse width modulation value 0 = off / 255 = 100%
Support Temp The support liquefier temperature and its set point in C.
Support PWM The pulse width modulation value 0 = off / 255 = 100%
Chamber Temp The actual chamber temperature and its set point in C.

Versions

Product Version The current version number for the complete
firmware release
Build Version The build number for current firmware
Firmware Version The current version for the firmware.
PLD Version The current version of the programmable logic
devices on the controller board.
Product serial The serial number of the complete system.
number

Travel Limits

If the box is checked the switch is tripped. NOTE: It is suggested, that due to
the time required to display switch state changes, that you use the LEDs on
the PDB to verify switch operations.
X home The X axis home limit switch state
X Limit The X axis end of travel limit switch state
Y Home The Y axis home limit switch state
Y Limit The Y axis end of travel limit switch state
Z Home The Z axis home limit switch state
Z Limit The Z axis end of travel limit switch state
Z Jam The Z jam encoder switch state
Z Foam The Z top of foam switch state.
-426