HP Designjet 3D Service Manual page 311

Figure 267: XY Table alignment bracket mounting locations
Place an alignment
bracket at the front of the
printer
5
44. Using a ⁄ " nut driver or standard screwdriver, loosen but do not
16
remove the left side X guide rod mounting screws.
45. Center the Y guide rods in the mounting slots and loosely tighten. See
Figure 268.
WARNING: Failure to center the Y guide rods before tightening the
X guide rod screws will result in X guide rod misalignment.
Figure 268: Center Y guide rods
46. Slide the translator to the left side of the printer.
5
47. Using a ⁄ " nut driver or standard screwdriver, securely fasten the left
16
side X guide rod mounting screws.
48. Slide the translator to the right side of the printer.
5
49. Using a ⁄ " nut driver or standard screwdriver, securely fasten the right
16
side X guide rod mounting screws.
Place an alignment
bracket at the back of the
printer
Position the Y guide rods so the
screw and washer are in the
center
-295