HP Designjet 3D Service Manual page 309
Hide thumbs
Also See for Designjet 3D:
- User manual (30 pages) ,
- Assembly instructions manual (12 pages) ,
- Assembly instructions (5 pages)
Table of Contents
Advertisement
12. Push the left side Y guide rod in towards the back of the printer.
13. Rotate the left side Y guide rod towards the left side of the printer and
raise the guide rod to the top of the frame.
14. Lower the left side Y guide rod into its mounting location.
5
15. Using a
⁄
" allen wrench, loosely reinstall the left side rear Y guide rod
32
mounting screw.
5
16. Using a
⁄
" allen wrench, loosely reinstall the left side front Y guide
32
rod mounting screw.
17. Reconnect the Y home sensor cable.
18. Align the right side Y guide rod with the mounting holes.
5
19. Using a
⁄
" allen wrench, loosely reinstall the right side rear Y guide
32
rod mounting screw.
5
20. Using a
⁄
" allen wrench, loosely reinstall the right side front Y guide
32
rod mounting screw.
21. Align the X guide rods with the mounting holes.
5
22. Using a
⁄
" nut driver or standard screwdriver, loosely reinstall the
16
right side X guide rod mounting screws.
23. Align the X motor energy chain mounting bracket with the mounting
holes.
5
24. Using a
⁄
" nut driver or standard screwdriver, reinstall the 2 X motor
16
energy chain mounting screws.
25. Reconnect the X motor cable.
26. Reinstall a wire tie around the X motor cable connector. See
Figure 265: X motor wire tie locations
Reinstall wire tie
27. Place the right side Y belt into the retaining clip.
28. Place the left side Y belt into the retaining clip.
29. Slide the translator to the back of the printer.
Figure 265.
-293
Advertisement
Table of Contents
Troubleshooting
