HP Designjet 3D Service Manual page 361

Figure 325: Measuring distance from outside edges of A and B
1 1. Next measure and record the distance from the outside edges of circle B
and C, see Figure 326
bump of circle C.
Figure 326: Measuring distance from outside edges of B and C
12. Add the lengths derived from steps 10 and 1 1 (A-B and B-C) and then
subtract the width of circle B. Record this total as "GFront"
13. Measure and record the distance from the outside edges of circles E and
F. Ensure the caliper is not seated on the small bump of circle E. See
ure 327
Figure 327: Measuring distances from outside edges of E and F
14. Measure and record the distance from the outside edges of circles F and
G. Ensure the caliper is not seated on the small bump of circle G. See
Figure 328
Ensure that the caliper is not seated on the small
Fig-
-345