HP Designjet 3D Service Manual page 232

12. Disconnect the 3 cables from the rear of the head board by pressing the
13. Using a
-216
Figure 144: Wire tie location
tabs in and pulling outward. See
Figure 145: Rear head board cable locations
Disconnect the 3
cables
5
⁄ " nut driver or standard screwdriver, remove the 4 toggle
16
head mounting screws. Toggle the head to the left to remove the bottom
right screw and toggle the head to the right to remove the bottom left
screw.
Cut and remove the
wire tie from the head
motor
Figure 145.