To Prevent Electric Shock; To Prevent Fire; To Prevent Injury - Mitsubishi Electric HG-MR Instruction Manual

1. To prevent electric shock, note the following
Before wiring and inspections, turn off the power and wait for 15 minutes or more (20 minutes or more for
converter unit and drive unit) until the charge lamp turns off. Then, confirm that the voltage between P+
and N- (L+ and L- for converter unit and drive unit) is safe with a voltage tester and others. Otherwise, an
electric shock may occur. In addition, when confirming whether the charge lamp is off or not, always
confirm it from the front of the servo amplifier (converter unit).
Ground the servo motor securely.
Any person who is involved in wiring and inspection should be fully competent to do the work.
Do not attempt to wire the servo motor until they have been installed. Otherwise, it may cause an electric
shock.
The cables should not be damaged, stressed, loaded, or pinched. Otherwise, it may cause an electric
shock.
To avoid an electric shock, insulate the connections of the power supply terminals.
2. To prevent fire, note the following
Install the servo motor on incombustible material. Installing them directly or close to combustibles will
lead to smoke or a fire.
Provide an adequate protection to prevent screws and other conductive matter, oil and other combustible
matter from entering the servo motor.
3. To prevent injury, note the following
Only the power/signal specified in the Instruction Manual must be supplied/applied to each terminal.
Otherwise, an electric shock, fire, injury, etc. may occur.
Connect cables to the correct terminals. Otherwise, a burst, damage, etc. may occur.
Ensure that polarity (+/-) is correct. Otherwise, a burst, damage, etc. may occur.
The servo motor, etc. may be hot while power is on and for some time after power-off. Take safety
measures such as providing covers to avoid accidentally touching them by hands and parts such as
cables.
The surface temperature of the servo motor may exceed 100 ˚C depending on its mounting and
operating conditions.
During operation, never touch the rotor of the servo motor. Otherwise, it may cause injury.
WARNING
CAUTION
CAUTION
A - 2