App. 9 Sscnet Iii Cable (Sc-J3Bus_M-C) Manufactured By Mitsubishi Electric System Service - Mitsubishi Electric MR-J4-10B(-RJ) Instruction Manual

APPENDIX
App. 9 SSCNET III cable (SC-J3BUS_M-C) manufactured by Mitsubishi Electric System &
Service
The cable is available per 1 m up to 100 m. The number of the length (1 to 100) will be in the underscore in
the cable model.
App. 10 Analog monitor
The servo status can be output to two channels in terms of voltage.
App. 10.1 Setting
Change the following digits of [Pr. PC09] and [Pr. PC10].
[Pr. PC11] and [Pr. PC12] can be used to set the offset voltages to the analog output voltages. Setting value
is -999 mV to 999 mV.
Parameter
PC11
PC12
POINT
For the details of the SSCNET III cables, contact your local sales office.
Do not look directly at the light generated from CN1A/CN1B connector of servo
amplifier or the end of SSCNET III cable. The light can be a discomfort when it
enters the eye.
Cable model
SC-J3BUS_M-C
POINT
A voltage of analog monitor output may be irregular at power-on.
[Pr. PC09]
0 0
[Pr. PC10]
0 0
This is used to set the offset voltage of MO1 (Analog monitor 1).
This is used to set the offset voltage of MO2 (Analog monitor 2).
App. - 45
Cable length
Bending life
1 m to 100 m
Ultra-long
1 to 100
bending life
Analog monitor 1 output selection
(the signal provided to the output across MO1 and LG)
Analog monitor 2 output selection
(the signal provided to the output across MO2 and LG)
Description
Application/remark
Using long distance
cable
Setting range [mV]
-999 to 999