Communication Function (Mitsubishi Electric General-Purpose Ac Servo Protocol) - Mitsubishi Electric MR-J4-10A(-RJ) Instruction Manual

18. MR-J4-03A6(-RJ) SERVO AMPLIFIER

18.9 Communication function (Mitsubishi Electric general-purpose AC servo protocol)

With MR-J4-03A6(-RJ) servo amplifier, driving servo, changing parameters, operating motor function, etc. is
possible using RS-422 communication (Mitsubishi Electric general-purpose AC servo protocol).
In this section, only the configuration of operating RS-422 communication function with MR-J4-03A6(-RJ)
servo amplifier is described. Refer to chapter 14 for details of the communication specification and protocol,
etc.
(1) Configuration diagram
(a) Diagrammatic sketch
Up to 32 axes of servo amplifiers from stations 0 to 31 can be operated on the same bus.
RS-422
compatible
controller
(b) Cable connection diagram
Wire the cables as follows.
RS-422
(Note 4)
compatible
controller
POINT
The USB communication function and RS-422 communication function are
mutually exclusive. They cannot be used together.
Servo amplifier
CN1
Axis No. 1 (station 0)
(Note 3) 30 m or less
(Note 1)
Axis No. 1 servo amplifier
CN1 connector
Plate
SD
13 SDP
14 SDN
39 RDP
40 RDN
31 TRE
3,28,
LG
30,34
Servo amplifier
CN1
Axis No. 2 (station 1)
(Note 1)
Axis No. 2 servo amplifier
CN1 connector
Plate
SD
13 SDP
14 SDN
39 RDP
40 RDN
31 TRE
3,28,
LG
30,34
18 - 82
Servo amplifier
CN1
Axis No. n (n - 1 station)
(n = 1 to 32)
(Note 1)
Axis No. n
(final axis) servo amplifier
CN1 connector
Plate
SD
13 SDP
14 SDN
39 RDP
40 RDN
31 TRE (Note 2)
3,28,
LG
30,34